Guitar Cut Out Template - The highway ones were relic models as i recall and yours might be stock. With the cut control turned to zero, nothing. Most of the fiddly stuff, the little pointy sprouts where the body gives way to the pocket, i can then do carefully by hand with a gent saw, files, and sandpaper. If you actually learn how to use the power tools and get a feel for how they operate, if you have the correct abrasive grit sizes, this is a piece of cake. I just built two 1x10 cabs and i remember them being 9 holes to cut (i think). My hair is the same length as yours right now , i am 68 and no grey hair and i have donated 10 times this round. When toni the tarantula gets bored, she goes to the kitchen and grabs a bugle out of the cupboard, wears it like a hat, and then parades around like it's a party or somethin'. Rout and install the trussrod from the back. Pickguard holes (for making your own pg). Then plane the body front down 1/4 leaving the fretboard standing. Basic paths to be followed for neck shaping and at head transition. The body gets cut out to a hair outside the pencil line of the perimeter on a bandsaw. So don't explain it all away to attack the body. If i was going to do a tele, i'd get a blank 2 x 13.5 x 40 and using a whole guitar template, cut it out with a band saw and then rout to the template. The shape is sanded to the line with a spindle sander, belt sander, and sanding block.
Rout And Install The Trussrod From The Back.
My hair is the same length as yours right now , i am 68 and no grey hair and i have donated 10 times this round. Generally the basket/gasket is 1/2 on all sides, so you generally cut the diameter one inch less than the speaker. You can take a lot of wood out and run a sheet of hardboard across the top. Most of the fiddly stuff, the little pointy sprouts where the body gives way to the pocket, i can then do carefully by hand with a gent saw, files, and sandpaper.
If You Actually Learn How To Use The Power Tools And Get A Feel For How They Operate, If You Have The Correct Abrasive Grit Sizes, This Is A Piece Of Cake.
She prefers the hot & spicy ones. I cut the body profile first, but leave a sprue at the neck (1) for neck pocket template attachment, and (2) for router stability when routing the neck pocket. Neck profiles at 1st and 12th frets; Neck routing for truss rods;
With The Cut Control Turned To Zero, Nothing.
Location of drilling between routs and for strap buttons. The most common cut control wiring, like in a vox ac15 or ac30, which is also used in some amps that are based on those amps, like some matchless and dr z designs, puts a pot and a cap between the two wires which are the input to the power tubes. Basic paths to be followed for neck shaping and at head transition. So don't explain it all away to attack the body.
Body Contours (Belly Cut, Arm Cut) Neck Overall;
The body gets cut out to a hair outside the pencil line of the perimeter on a bandsaw. If i was going to do a tele, i'd get a blank 2 x 13.5 x 40 and using a whole guitar template, cut it out with a band saw and then rout to the template. Turn it sideways and cut out the headstock front and the back of the neck. I just built two 1x10 cabs and i remember them being 9 holes to cut (i think).